0.6/1KV Steel wire armoured Power Cable

Power Cable -Conductor: Solid or stranded Aluminu-Insulation: Cross-linked polyethylene( XLPE or PVC) -Circuit Identication: The insulation shall be red, black -Filler: Polypropylene lament withlapped binding tape -Inner Sheath: Polyvinyl chloride (Black) -Armor: Galvanized steel wire/steel tape/Unarmored/Aluminum wire -Core-covering: Binding tape -Outer Sheath: Polyvinyl chloride (Black)-Application: For use in ducts, trays and direct burial in ground. The cable is subject to immerse in water all the time. -Standards / Testing Specications: IEC 60502-1.Installation Thiscable can be installed in duct, tray or direct burial. It is recommended that the installation instructions indicated by the Local Electric Code, or any equivalent, be followed,so that the safeguarding of persons and the integrity of the product will not be affectedby eciencies in the installation.XLPE Insulation Power Cable The Application of Power Cable Power Cable is used to transmit power on power distribution circuit of AC 50HZ, rated voltage 35 KV or lower. It has not only excellent electrical performance, mechanical performance, heat-resistant & anti-aging performance, environment resistant character & chemical-corrosion resistant performance, but simple structure, light weight, without restriction by laying fall, and it also has high temperature (90) for long term Instruction I. Executive Standard: GB12706.1.3 adopts international electrician committee IEC60502 II. Working Features: 1. Environment temperature should be no lower than 0 for laying, the cable fall without limitation 2. The min bending radius of cable is stipulated as follows: Single core: 20(d+D) 5% three cores: 15(d+D) 5% (D is actual diameter of cable; d is actual outer diameter of conductor). 3. Operation temperature of cable PVC sheath is no more than 90. 4. Max rated temperature of cable conductor is 90 , and no higher than 250 in time of short circuit (max. Lasting time is no longer than 5s).